How to upload FPGA settings to tagger ULM

After tuning on the tagger crate, you have to upload FPGA settings to ULM1 & ULM2.
  1. Go to the place where tagger crate is set (above the storage ring).
  2. Make sure windows machine is turned on.
  3. Open Quartus 2000.9.
  4. Click "Processing" & choose "Open programmer".
  5. Connect "cable1" (flat cable) to a connector mounted to the windows machine.
  6. Click "Add files" & choose "Desktop/NewTagger/ulm1/ulm1.sol"
  7. Click "Add files" & choose "ulm1.sol" again.
  8. Check "configure" box only in the second line.
  9. Click "start" button.
  10. If you see a message with "program succeeded", it is OK.
  11. Repeat the same process for "ulm2".

If you forget to do this, tagger rate is low.

Last modified: Tue Jul 15 09:01:32 JST 2008