Useful commands

警告

This is an archived article. It preserves the previous documentation and may not match current environments.

New documentation

Artemis has several available commands.

You need to register the commands in artemislogon.C.

Below is a list of commands that the author frequently uses.

  • help : Type this when you forget a command.
  • add : A command to read a yaml file.
  • res : A command to start an analysis using the loaded yaml file.
  • fls : Outputs a list of the loaded TFiles.
  • fcd : Specifies the number for a TFile.
  • proc : Outputs the parameter list required for the processor.
  • zone : Creates the standard TCanvas (artcanvas) in Artemis.
  • gcom : Sets global comment on artcanvas (doesn’t disappear even if you execute ‘zone’).
  • comment : Sets comment on artcanvas (disappears when you execute ‘zone’).
  • save : A command to save the artcanvas in .root, .pdf, and .png formats.
  • lgz : Sets the z-axis to a logarithmic scale. lgx and lgy are also available.
  • lnz : Sets the z-axis to linear. lgx and lgy are also available.
  • ht : Draws the histogram by specifying its number.
  • hn : Draws the histogram of the next number.
  • hp : Draws the histogram of the previous number.
  • slo : Uses GUI to draw a straight line on artcanvas.
  • avx : Slices TH2 for each X bin and fits it with a Gaussian.